Toho-electronics TTX-700 Manual de usuario descargar pdf (Pagina 33)

6.11.8 Changing the settings (SV or SV2) by communications during auto-tuning

Even if the settings (SV or SV2) used in control for auto-tuning are changed by communications,

the changes (SV or SV2) will not be changed until the auto-tuning ends.

6.12 Example of LRC calculations

Following is an example of calculating LRC with VisualBasic6.0.

Variables are declared as shown below.

VisualBasic6.0 cannot use code-free variables. It therefore uses code-equipped 16-bit integer

variables as data. Similarly, the LRC calculation results are entered into code-equipped 16-bit

integer variables.

Dim LRC As Integer

Dim i, arry_count As Integer

Dim lrc_arry(128) As Integer

Then enter calculable data into the 1rc_arry(), and enter the number of data items into the

arry_count. After that, run the following program to cause the calculation results to enter the LRC.

For i = 0 To arry_count

LRC = (LRC + lrc_arry(i)) And &HFF

LRC = ((Not LRC) + 1) And &HFF

If the error code is calculated as 12H as an example, affix a "1" or "2" at the end of the message.

３３

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Sin comentarios

Toho-electronics TTX-700 Manual de usuario Pagina 33