Toho-electronics TTM200 Manual de usuario descargar pdf (Pagina 227)

48-7009-E 6-79

■Repeat Start Step Setting / Repeat End Step Setting / Setting the Times of Execution / Setting the no. of

Execusion / No. of Times Monitor

ＳＥｔ２２

ＰＲＯＧ

Setting Contents

Initial

Value

ＳｔＲＳｔ

Repeat Start Step Setting 3

Setting Value Range 1～Repeat End Step Setting

(ENdSt)

ＥＮｄＳｔ

Repeat End Step Setting 3

StEPN

Repeat Start Step Setting (StRSt StRSt)～

Setting No. of Steps to be used or StEPN

※When set to StEPN, the value which is set under the

Setting No. of Steps to be Used will be “Repeat End Step

Setting”.

ＲＵＮＰ

No. of Execution Setting / No. of Execution Monitor 3

Setting Value Range RUNP=0～9999

（When RUNP=0, Infinite）

Setting the condition of repeated operation during the programmed operation

＊5 Repeated Start Step Setting (StRSt)

This is to set the starting point of the repetition (Step No. of which the repetition starts)

＊6 Repeated End Step Setting (ENdSt)

This is to set the end point of the repetition (Step No. of which the repetition ends)

＊7 Setting No. of Executions / No. of Executions Monitor (RUNP)

This is to set the no. of time of repetition at the start point and end point.

NOTE: The setting value of the “No. of Executions Setting ” and “No. of Executions” done will be shown alternately only

on the display of the controller unit.

■Repeat Operation Behavior Diagram

STEP1 STEP2 STEP3 STEP2 STEP3 STEP2 STEP3 STEP4

programmed

operation

start

Repeated Start Step Setting : STEP2

Repeated End Step Setting : STEP3

Setting No. of Executions 　: 3 times

programmed

operation

end

Above is usage example of Repeat Operation Function

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 263 264

Comentarios a estos manuales

Sin comentarios

Toho-electronics TTM200 Manual de usuario Pagina 227

Comentarios a estos manuales