Toho-electronics TTM200 Manual de usuario descargar pdf (Pagina 229)

48-7009-E 6-81

■Bank Automatic Switching Source Setting

ＳＥｔ２３

ＺｂＮＫ

Setting Contents

Initial

Value

ｂＡＳ

Bank Automatic Switching Source Setting 3

Function

Select SV value

Select ramp SV value

Select PV value

Control Mode Interlock Function

All Mode

RUN/MAN Mode Only

RUN Mode Only

※Select the source for the SV value to which the

Bank Automatic Switching will be done.

※When “SET04 bANKH=0”, the setting will be

invalid.

There will be no indication either.

※２ Bank Automatic Switching Source Setting (bAS)

Select source to which the Bank Automatic Switching will be done. Switch the bank in accordance with

the source selected.

Setting Range：When 0, select SV Value ＜Local and Remote (only Option Y)＞

：When 1, select ramp SV value.

：When 2, select PV value

NOTE: The behavior of AT (Auto-Tuning) when (bAF = 1).

・ Regardless of the source setting to which the Bank Automatic Switching will be done, it will select

SET04(SV). After the completion of the AT (Auto-Tuning), it will go back to Bank Automatic

Switching Source Setting (bAS).

・In case the Zone Threshold＊Setting (PM＊) is set, at the same time the parameter (P, I, D) is set to the

bank, the PID value obtained from the AT (Auto-Tuning) will be reflected to the Bank No. according to

the threshold.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 263 264

Sin comentarios

Toho-electronics TTM200 Manual de usuario Pagina 229