Toho-electronics TTM200 Manual de usuario descargar pdf (Pagina 90)

48-7009-E 5-20

5.3.8 How to set MD/READY

★ Start of control (RUN) or stop of control (READY) is selected.

Switchover of RUN/READY can be executed through the key operation with the FUNC key assigned,

or through optional digital (DI) input or communication function.

① Setting with the function key

★

☆

For constant value run mode screen:

PV value (present value)

SV value (target value)

Hold MODE key pressed for 2 seconds.

Input 1 setting screen

Each set screen

Each setting mode

Press the ▲ key twice. Press it, however, once for TTM-204.

Key function setting screen

Press MODE key.

S03-1 Function key 1 function setting screen

Each set screen

Each setting mode

* The function key functions are set in this screen.

For content of key functions, see the function key function assignment table on page 4-21.

* The number displayed in the screen is coincident with that listed in the assignment table.

* Use the ▲/▼ key for setting the numbers.

* The value is set at “00” at factory shipment.

* To be set as follows: ★ = Time of holding the function key pressed and ☆ = 2 (control

start/control stop).

★ = 0: None, 1: 1 second, 2: 2 seconds, 3: 3 seconds, 4: 4 seconds and 5: 5 seconds

* Use the MODE key to move the screen for the setting screen to set the function keys 2 to 5.

The screens change in sequence each time when the MODE key is pressed.

(Note that only the function key 1 is available for TTM-204.)

* The above operations determine the setting of the function (FUNC) key to be the control start (RUN) and control

stop (READY).

* Pressing the function (FUNC) key in the operating mode screen results in operations of RUN and READY.

* Any function key can be assigned for RUN or READY on all equipment models except TTM-204.

* Holding the MODE key pressed for 2 seconds moves each setting screen to the run mode screen.

* In about 2 minutes, each setting screen (or any setting screen) automatically moves back to the run mode screen.

Hold MODE key pressed for 2 seconds.

For program run mode screen:

PV value (present value)

SV value (PRoG)

Hold MODE key pressed for 2 seconds.

Setting mode is the same as that for Hereinafter,

to the input 1 setting screen similarly to that for

the constant value run mode

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 263 264

Comentarios a estos manuales

Sin comentarios

Toho-electronics TTM200 Manual de usuario Pagina 90

Comentarios a estos manuales