Toho-electronics TTM200 Manual de usuario descargar pdf (Pagina 87)

48-7009-E 5-17

5.3.6 Excessive ascent prevention unit (alarm unit) setting

★ Setting for the excessive ascent prevention unit

Setting to use the OUT 1 (output 1) as the excessive ascent prevention unit in constant value run mode

Hold MODE key pressed for 2 seconds.

Constant value run mode screen

PV value (present value)

SV value (target value)

Press the ▲ key four times. Press it, however, three times for TTM-204.

Input 1 setting screen

Each set screen

Each setting mode

OUT 1(output 1) setting screen

Hold MODE key pressed for 2 seconds.

Each set screen

Each setting mode

Press MODE key once.

S05-1 Target connection selection screen

* Target connection is set in this screen.

* Use the ▲/▼ key for the setting.

* The value is set at “0” at factory shipment.

Changing the setting from “0” to “2” results in the event output.

S05-2 Event function 1 setting screen

Press MODE key once.

* Event function is set in this screen.

* Use the ▲/▼ key for the setting.

* The value is set at “000” at factory shipment.

Set the screen “006” or “016” for the use of the excessive ascent prevention unit

(alarm unit). In case of the setting of “016,” the displayed value may exceed the

target value, and it stays as is even when it decreases below the target value.

The setting is reset by turning on the power again.

S05-3 Event upper limit setting mode

* Event upper limit is set in this screen.

* Use the ▲/▼ key for the setting.

* The value is set at “0” at factory shipment.

Set a specific target value.

* Holding the MODE key pressed for 2 seconds moves each setting screen to the run mode screen.

* In about 2 minutes, each setting screen (or any setting screen) automatically moves back to the run mode

screen.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 263 264

Sin comentarios

Toho-electronics TTM200 Manual de usuario Pagina 87